Zusammenfassung
Der Bericht ist ausschließlich als PDF-Dokument erschienen!
Inhalt
Vorwort 1
Keynote
Mobilitätsszenarien und deren Einfluss auf Einsatz und Entwicklung von Kupplungssystemen – Einfluss aktueller Trends auf die Anforderungen an Kupplungssysteme 3
A. Albers, S. Ott, IPEK-Institut für Produktentwicklung am KIT, Karlsruhe
Trockenlaufende Kupplungen – energieeffiziente und zukunftsfähige Systeme
Trockenlaufende Lamellenkupplungen – Eine neue Option zur Verwirklichung einer hochintegrierten aktiven Drehmomentregelung für konventionelle und elektrifizierte Antriebe 13
F. Nickel, M. Mühlegger, Miba Frictec GmbH, Roitham, Austria
Experimental characterization and modeling of automotive dry clutch friction lining wear – Clutch lifetime prediction 25
M. Hoic´, B. Škugor, J. Deur, University of Zagreb, Zagreb; Croatia;
A. Tissot, Ford-Werke GmbH, Cologne
Analyse des Schädigungs- und Erholungsverhaltens trockenlaufender Friktionspaarungen 37
T. Klotz, S. Ott, A. Albers, IPEK – In...
Schlagworte
Kupplung Antrieb Ettlingen Erholungsverhalten Trockenlauf Friktion Hybridgetriebe- 1–2 Vorwort 1–2
- 3–12 Keynote 3–12
4 Treffer gefunden
- „... well-established AVL-DRIVETM tool enabling: Model Based Development (MBD) of complex and critical HW and SW ...” „... development, and later in control plant model form, enabling MiL and SiL based mechatronic function and SW ...” „... trade-off between EM power reserve and achievable driveability, to demonstrate model based development ...”
- „... parameters such as temperature, slip speed, and closing time. A cycle-based wear model is presented, as well ...” „... to remaining input-output data, (iii) predicting of wear rate based on the obtained model and the ...” „... found to include 6 parameters, and it reads (2) where denotes model-based estimate of wear ...”
- „... . . . . . . . . . . . . . . . . . . . . .47 K.-L. Kimmig, B. Wolf, Schaeffler, LuK GmbH & Co. KG, Bühl Driveability lead Model Based ...” „... Development of HW & SW for P2 Hybrid Impulse Start – A novel methodology supporting virtual development of ...”
- „... different test setups were considered. Based on [11] these two setups can be classified as simplified ...” „... stroke. The torque was increased with rising stroke until the turning point, to model the characteristic ...” „... . The nominal surface pressure of 25 N/mm² employed was calculated based on Eq. (1) introduced for a ...”